5 Steps of Water Heater Installation in Buffalo Grove
- Water Heaters
Hiring a licensed local plumber for water heater installation in Buffalo Grove will save you time, money, and sweat off your brow – not only that, but it may also be an issue of safety. Not every handyman is properly qualified to install your water heater up-to-code – only an actual plumber has the tools and skills you need. Seeking anything less than top-notch professional service can, if you excuse the pun, land you in hot water.
Although we don’t recommend you try it yourself, the team at Lake Cook Plumbing want you to understand the process taken by a professional to give you a better understanding of what it takes to get the job done. Make no mistake, when it comes to water heater installation in Buffalo Grove, it’s best to leave it to the pros.
Water Heater Installation in Buffalo Grove: How’s it Done?
While some steps may vary depending on the location, appliance model, and power source, the basics are always the same. Here’s the general process broken down into 5 steps:
- Set-Up – First, make sure the gas and water main valves are fully closed. Drain the existing water tank into a bucket and remove the water. It’s also important to make sure you have the right amount of tools for the job.
- Hook-up Your Water Heater to a Power Source –Water heaters can come as either electric or natural gas powered models. An electric model will need to be wired with 30 amps of electricity for a 40-gallon model. A natural gas model must be connected to a gas line, which will always need to be done carefully – you don’t want to strip the screw or cross threads!
- Establish Proper Ventilation – Your current water heater has ventilation in place to carry away dangerous byproduct gasses from your water heater to the outdoors. However, the new model may have a different ventilation set-up. It is very important to make sure the ducting travels from the heater to the outside with no leaks, cracks, or bending.
- Attach the Water Lines –Be sure to screw each pipe in tightly! Flexible PVC connectors are easier to install, but you should use copper piping wherever you expect there to be heat.
- Test Operation – Check to see that the pilot light is fully blue, not yellow or orange, and that smoke is being pulled through the ventilation. Make sure there are no leaks – you can do this by running soap water through your water heater and then inspecting for bubbles at the seams.
Though it may seem like a long, time-consuming process, it’s quicker than ever if you call up Lake Cook Plumbing for water heater installation in Buffalo Grove!